SR 5600
English
18
Checking Flow Rate
N Place the unit on the ground.
N Fill the container with water up to
10 liter mark.
Machines without pressure pump
N Set the "standard" metering knob to
6.
N Start the machine.
N Hold the spray tube horizontally, run
the engine at full throttle, spray the
contents of the container down to
the 5 liter mark and note the time
taken.
The time required to spray 5 liters fluid
should be betweeen 90 and
120 seconds.
Machines with pressure pump (special
accessory)
N Set the metering knob to position 2.
N Start the machine.
N Hold the spray tube horizontally, run
the engine at full throttle, spray the
contents of the container down to
the 5 liter mark and note the time
taken.
The time required to spray 5 liters fluid
should be betweeen 80 and
110 seconds.
In case of deviations:
N Check the container, hose system,
metering knob and optional
pressure pump for cantamination
and clean if necessary.
N Check blower air intake and clean if
necessary.
N Check engine setting and correct if
necessary.
If there is no improvement, contact your
dealer for assistance.
N Stand the sprayer on a level
surface.
N Close the stop cock.
N Fill up with thoroughly mixed spray
solution – do not exceed 13 liter
mark (arrow).
N The gasket (1) in the cap must
always be lubricated with grease.
N Fit the cap and tighten it down
firmly.
Filling the Container
To Next Page
Loading...
