Stihl TS 350 - Maintenance Chart; Machine Component Checks; Filter and Carburetor Maintenance; Spark Plug and Wheel Checks

The following information refers to normal operating conditions.
The specified intervals must be reduced accordingly when working under
aggravated conditions (severe dust formation, etc.) and with longer daily
working hours.
Before starting work After work or daily Every time after refuelling Weekly Monthly In the event of a malfunction If damaged As required Refer to page
Complete machine
Visual inspection (condition, absence of leaks)
xx
Clean
x
Throttle trigger, throttle trigger interlock,
slide control Functional test
xx
Filter in fuel tank
Check
x
Replace
x
Fuel tank Clean
x
V-belt
Clean
x16
Replace
xx 27
Air filter (prefilter, auxiliary filter) Clean
xx23
Air filter (all filter components) Replace
xx 23
Cooling air intake ports Clean
x
Cylinder fins Clean
x
Spark arresting screen in the muffler
Inspect
x28
Clean or replace
x28
Carburetor
Check idle speed -
the cutting wheel must not run on
xx 24
Adjust idle speed
x24
Spark plug Adjust electrode gap
x22
Accessible nuts and bolts
(but not adjusting screws)
Retighten
x
Rubber buffer (AV element)
Have replaced by the
STIHL customer service
x
Abrasive wheel
Check
xx
Replace
xx 18
Support/Bracket/Rubber buffer
(Bottom side of unit)
Check
x
Replace
xx
0DLQWHQDQFHFKDUW
The user of this unit should carry out
only the maintenance operations
described in this manual. Other repair
work may be performed only by an
authorized STIHL Service dealer.
:DUUDQW\FODLPVIROORZLQJUHSDLUV
FDQEHDFFHSWHGRQO\LIWKHUHSDLU
KDVEHHQSHUIRUPHGE\DQDXWKRUL]HG
67,+/6HUYLFHGHDOHUXVLQJRULJLQDO
67,+/VSDUHSDUWV
Original STIHL parts can be identified
by the STlHL part number, the
T logo and the STIHL parts
symbol  The symbol may appear
alone on small parts.
76 