Stihl TS 410 - Page 12

Page 12 Technical Information 37.2007
TI_37_2007_30_01_02.fm
3. Cutting wheels
4. Accessories
4.1 Cutquik
®
cart FW 20 with support
attachment kit for TS 410, 420
The STIHL Cutquik
®
cart FW 20 (4224 200 0004)
combines the Cutquik
®
cart (basic unit) with the new
support attachment kit (4238 790 0702) for TS 410,
420.
The new support attachment kit (4238 790 0702) for
TS 410, 420 can be mounted on an existing STIHL
Cutquik
®
cart FW 20.
Only the corresponding attachment kit is needed
when converting the FW 20 for use with another
STIHL cut-off machines.
TS 410 TS 420
Diamond cutting wheels:
Depending on version, can be used for cutting
asphalt, concrete, stone (hard rock), abrasive
concrete, green concrete, clay bricks and clay
pipes
Diameter: 12 in (300 mm) 14 in (350 mm)
Composite cutting wheels:
Depending on version, can be used for cutting
asphalt, concrete, stone, ductile cast iron pipes
and steel
Diameter: 12 in (300 mm) 14 in (350 mm)
Part name Part No. Use
Cutquik
®
cart FW 20 with support
attachment kit for TS 410, 420
4224 200 0004 Cutting with guidance on level surfaces
– Support attachment kit for TS 410, 420 4238 790 0702 For mounting on the Cutquik
®
cart FW 20
– Water tank mounting kit 4224 007 1011 For dusty conditions
– Guide wheel kit 4205 007 1009 Accurate guidance along a drawn line
Water tank 4223 670 6000 For dusty conditions
Wheel kit 4224 007 1014