Stihl TS 410 - Reactive Forces including Kickback; Pull-away, Climbing, Pinching and Rotational Kickback Forces

Page 14 Technical Information 37.2007
TI_37_2007_30_01_02.fm
5.2.1 Rework note: Washer 5910 893 2102 from
service tool 5910 007 2200
Service tools 5910 007 2200 supplied from factory
will in the future include the modified washer and
three additional holes with a diameter of 7/32" (5.5
mm) for use with the TS 410, 420. An existing
washer without these holes can be reworked in
accordance with the template drawn to scale below.
To mark the new holes, copy the template, cut it out
and place it on the washer. The figure 21 must be
stamped on the upper side, alongside each of the
new holes, for identification.
42.2
21.1
38.2
370TI010 KN
11.2
21
34.4
17.3
21
21