Technical Information 37.2007 Page 15
TI_37_2007_30_01_02.fm
5.3 Servicing accessories
6. Spare parts
The spare parts lists for TS 410, 420 will be
available when the machines are launched on the
market.
The new machines are included in the STIHL
Service Communication System (SCS / MediaCat
CD-ROM) from edition 03/2007 onwards.
7. Servicing
The specific national safety regulations and the
safety instructions in the instruction manual must be
observed if the machine has to be started up during
servicing.
7.1 Tightening torques
Tightening torques are specified in the Service
Manual STIHL TS 410, 420.
7.2 Service note
The Service Manual STIHL TS 410, 420 is available
for servicing and repair of the machines.
7.3 Serial number
The serial number is located on the tank housing,
underneath the machine, as illustrated above.
Part name Part No. Use
Set of gaskets 4238 007 1003 Shortblock
Set of carburetor parts 4238 007 1060 Carburetor C1Q-S118
Lubricating grease (225 g tube) 0781 120 1111 Oil seals, sliding and bearing points
STIHL special lubricant 0781 417 1315 Bearing bore in the rope rotor, rewind
spring in the starter cover
Press Fluid OH 723 0781 957 9000
STIHL multi-purpose grease 0781 120 1109
Tube of sealant Dirko HT red 0783 830 2000 Engine pan, oil seals (outside)
Loctite 242 0786 111 2101
Loctite 270 0786 111 2109
Loctite 648 0786 111 2117
Standard solvent-based degreasant not
containing any chlorinated or
halogenated hydrocarbons
Cleaning the mating faces and
carburetor, crankshaft stub and cone in
flywheel
#
370TI007 KN
To Next Page
Loading...
