Page 16 Technical Information 37.2007
TI_37_2007_30_01_02.fm
7.4 Repair times
The specified repair times apply for trained and
qualified personnel as well as for properly equipped
repair shops.
The repair times are specified in minutes.
© ANDREAS STIHL AG & Co. KG, 2007 Technical Documentation
D1/MTK-fr
Repair activity TS 410,
TS 420
1 Replace engine or short block -
2 Replace wheel guard 20
3 Replace wheel bearing bracket
assembly. 25
4 Replace belt pulley on wheel arbor. 15
5 Replace wheel arbor shaft. 15
6 Replace arbor shaft bearing. 25
7 Replace belt pulley on clutch end. 25
8 Replace drive belt. 15
9 Replace front handlebar. 15
10 Replace cast arm from engine to
wheel. 25
11 Replace crankcase, crankcase
gasket or re-seal crankcase.
Includes air leak test. 160
12 Replace crankshaft main
bearing(s). Includes air leak test. 170
13 Replace crankshaft seal(s).
Includes air leak test. 70
14 Perform engine air leak test. 30
15 Replace cylinder and/or piston.
Includes air leak test and repair of
components causing failure. 90
16 Replace ignition module or flywheel.
Includes stop circuit test. 25
17 Replace fuel tank line, vent line, or
fuel pick-up body. 40
18 Replace intake or transfer port
manifold or intake flange. 35
19 Repair or replace carburetor.
Includes fuel system testing. 45
20 Repair or replace rewind starter. 15
21 Repair or replace clutch, clutch
shoes or clutch springs. 20
22 Replace rear handle frame or
handle housing. 45
23 Replace muffler 25
24 Replace air filter or filter housing 15
25 Repair or replace stop switch.
Includes circuit testing. 35
40 Miscellaneous repairs and other
repairs not listed. 15
45 Handling allowance only-no labor. 10
50 No Labor 0
To Previous Page
Loading...
