TS 480i, TS 500i
English
44
Installing the spark plug
N Check the electrode gap of the
spark plug and adjust it as
necessary. See specifications
N Install the spark plug by hand and
screw it in
N Tighten the spark plug with an
appropriately sized combination
wrench
N Press the spark plug boot firmly
onto the spark plug
N Position the cap for the spark plug
boot and screw it down securely
N Undo the nuts (1)
N Turn the tensioning nut (2)
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
N Pull the water hose out of the guide
in the V-belt guard
N Loosen the screw (3)
N Raise the V-belt guard (4) slightly
and pull it off to the front
N Remove the V-belt from the front
pulley
N Remove the nuts (1)
N Remove the starter cover (5)
N Do not remove the "cast arm and
guard" (6) – hold it in place on the
studs until the starter cover is fitted
back in position
N Remove the old V-belt
N Carefully insert the new V-belt (7)
on the V-belt pulley (8) on the
engine and the front V-belt
pulley (9)
NOTICE
The belt action must run smoothly.
Replacing the V-belt
To Next Page
Loading...
