Stihl TS 480i - Limited Warranty; STIHL Incorporated Federal Emission Control Warranty Statement; Your Warranty Rights and Obligations; Manufacturers Warranty Coverage

TS 480i, TS 500i
English
50
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
STIHL Injection
Control unit with characteristic-curve-
driven ignition timing adjustment
Load dependent, characteristic-curve-
driven fuel injection
Electronic water control
The electronic water control makes it
possible to feed the optimum amount of
water to the abrasive cutting wheel. No
water is fed to the abrasive cutting wheel
during idling.
Engine
STIHL single cylinder two-stroke engine
TS 480i
TS 500i
Spark plug, fuel tank capacity
Air filter
Main filter (paper filter) and flocked wire
mesh auxiliary filter
Weight
Abrasive cutting wheels
The quoted maximum permissible
operating speed of the abrasive cutting
wheel must be greater than or equal to
the maximum spindle speed of the cut-
off machine used.
Abrasive cutting wheels (TS 480i)
Specifications
A = 300 hours
B = 125 hours
C = 50 hours
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Displacement: 4.41 cu in
(72.2 cm
3
)
Cylinder bore: 2.05 in (52 mm)
Piston stroke: 1.34 in (34 mm)
Engine power accord-
ing to ISO 7293:
5.2 hp (3.9 kW)
at 9300 rpm
Idling speed: 2500 rpm
Max. spindle speed: 5350 rpm
Displacement: 4.41 cu in
(72.2 cm
3
)
Cylinder bore: 2.05 in (52 mm)
Piston stroke: 1.34 in (34 mm)
Engine power accord-
ing to ISO 7293:
5.2 hp (3.9 kW)
at 9300 rpm
Idling speed: 2500 rpm
Max. spindle speed: 5350 rpm
Spark plug
(suppressed): Bosch WSR 6 F
NGK BPMR 7 A
Electrode gap: 0.02 in (0.5 mm)
Fuel tank capacity: 24.5 oz (0.725 l)
Without fuel, without abrasive cutting
wheel, with electronic water control
TS 480i: 22.0 lbs
(10.0 kg)
TS 500i: 22.5 lbs
(10.2 kg)
Outside diameter: 12 in.
(300 mm)
Max. thickness: 0.189 in.
(4.8 mm)
Bore diameter/spindle
diameter:
0.787 in.
(20 mm)
Tightening torque: 22 lbf ft
(30 Nm)