Operation 4
Check and actions prior to use
List of checks prior to start-up
WARNING
Damage or other defects on th
e forklift truck or
attachments (special equi
pment) can result in
accidents.
If damage or other defect
sarenoticedonthetruck
or attachments (specia
l equipment) during the
following inspections
, do not use the truck until
it has been properly re
paired. Do not remove or
disable the safety sys
tems and switches. Do not
change the pre-set va
lues.
WARNING
Risk of falling!
When working on high-level parts of the truck, do
not use truck components for access or to stand on.
– Use suitable access equipment.
Ensure that the truck is in good working
condition prior to start-up.
To do this, carry out the following checks:
– Fork arms or other load-carrying equipment
should not show any signs of noticeable
damage (for example: bending, cracks,
significant wear).
– Check that there are no signs of leaking
consumables under the truck.
– Do not restrict the field of vision. Ensure the
visible area specified by the manufacturer
is observed.
– Attachments (special equipment) must be
properly secured and function according to
their operating instructions.
– Damaged or missing stickers m
ust be
replaced in compliance wit
hthemarking
position table.
– The roller guide rails must be coated in a
visible layer of grease.
– The wheels must show no signs of defects
or heavy wear. The mounting must be
correct.
– Check that there are no fo
reign objects that
could hinder the operati
on of the wheels
and rollers.
– The warning devices (horn etc.) must work.
– The battery cover must be closed.
– Check that the covers are
correctly posi-
tioned.
– The operator must be qualified to drive the
truck. The operator must be able to reach
the controls and operate them (especially
the anti-crush device). Do not obstruct
access to the controls.
Please inform your supervisor if you notice
any defects.
113
3 801 16 01 EN - 11/2018 41
To Next Page
