StimTec TARGET - TENS and EMS Programs and Parameters

There are a total of 33 programs available:
For TENS treatment:
Program 0-11 --- TENS Preset programs
Program 12-19 --- TENS Manual programs
For EMS treatment:
Program 20-29 --- EMS Preset programs
Program 30-33 --- EMS Manual programs
In EMS preset modes (Prog 20- Prog 29) the treatment
status symbols below will be displayed.
Pressing these two keys to go through and
select the following parameters one by one (manually
selectable only):
TENS Manual Mode(P12-P19) :
FREQUENCY (Hz)
PULSE WIDTH (μs)
Waveform
Treatment Timer (min)
EMS Manual Mode(P30-P33) :
FREQUENCY (Hz)
PULSE WIDTH (μs)
Waveform
Treatment Timer (min)
SYNCHRONOUS/ALTERNATING
ON TIME (sec)
OFF TIME (sec)
RAMP UP TIME (sec)
RAMP DOWN TIME (sec)
- 15 -