When one of the above parameters has been selected,
the corresponding digits or letters or symbols on the LCD
are flashing, then you can use “+” or “–” key to adjust that
parameter value. Press a “MENU” key to save the value
and skip to the next parameter setting. If there is no input
detected within 5 seconds, the unit will automatically save
the value you last set as the treatment parameter.
When MENU (▲/ ▼) key is pressed, the output level
goes immediately to zero.
By pressing “+” or “–” keys you can increase
or decrease the value of the parameter which has been
selected by the “MENU” keys and is now flashing. An
auto-repeat function is available; when +/- key is held
down over 1 second, the value of the parameter will
increase/decrease 1 step per 1/4 second until the key is
released.
Pressing this key will pause the current
treatment. When the unit is paused, the intensity level
goes down to zero, and “►II” is displayed on the LCD. To
continue, press the key again. The treatment will
continue at the same intensity and progress prior to being
paused.
Press and hold this key for at least 3 seconds to
LOCK or UNLOCK parameters. When the unit is locked,
only intensity and treatment timer can be adjusted.
The symbol displayed on the LCD screen indicates
that the unit is locked.
- 16 -
To Next Page
Loading...