EasyManua.ls Logo

STINAR PS-813B/E - User Manual

STINAR PS-813B/E
70 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
sales@stinar.com | P 651.454.5112 | F 651.454.5143 | www.stinar.com REV.10.2020
PASSENGER STAIRWAY
OPERATION & MAINTENANCE MANUAL
MODEL: PS-813B/E

Table of Contents

Questions and Answers

  • L
    Latoya FowlerAug 4, 2025
    Why STINAR Lifting Systems stairway or A-frame will not raise?
    • R
      Rachel BellAug 4, 2025
      If the stairway or A-frame of your STINAR Lifting System won't raise, several issues could be the cause: * The fluid level in the hydraulic reservoir might be low; if so, fill it to the proper level with the specified fluid. * There may be leakage in the hydraulic lines or fittings; inspect these and tighten or replace them as necessary. * The pressure relief might be set too low; adjust the pressure relief per Section 3. * There could be a control valve defect requiring repair or replacement. * A hydraulic pump problem may also be the cause, requiring repair or replacement.
  • J
    Jill JonesAug 10, 2025
    What to do if STINAR Lifting Systems engine will not crank?
    • T
      Tara McclureAug 10, 2025
      If the engine of your STINAR Lifting System won't crank, check the following: * The battery may be discharged; check the batteries and recharge if needed. * There might be an electrical problem; see electrical troubleshooting.
  • T
    Tammy RodriguezAug 14, 2025
    Why STINAR Lifting Systems stairway or A-frame raises too slowly?
    • M
      Marcia SandersAug 14, 2025
      If the stairway or A-frame on your STINAR Lifting System raises too slowly, consider these potential causes: * The oil level in the hydraulic tank may be low; add oil to the tank. * The relief valve might be set too low; adjust it per Section 3. * There could be an internal control valve leak, which would require repair or replacement. * An internal stairway cylinder leak may exist; repair the cylinder (see Figure 4.3.8). * There might be an internal A-frame cylinder leak; repair the cylinder.
  • M
    marymorseAug 20, 2025
    What to do if STINAR Lifting Systems unit will not turn?
    • M
      Mr. Frank Hood DDSAug 20, 2025
      If your STINAR Lifting System unit will not turn, it may be due to: * The caster pivot needing lubrication; grease it. * The caster pivot being frozen; replace the caster.
  • K
    Kevin JamesAug 25, 2025
    Why STINAR Lifting Systems unit will not move easily?
    • O
      ogriffithAug 25, 2025
      If your STINAR Lifting System unit does not move easily, it could be because the wheel bearing is frozen. Repack or replace it to resolve this.
  • J
    James GoodmanAug 29, 2025
    What to do if A-frame will not extend or retract in STINAR Lifting Systems?
    • C
      Chad WattsAug 29, 2025
      If the A-frame of your STINAR Lifting System will not extend or retract, check for foreign objects or bent tubes that may be causing the A-frame tubes to bind.

Summary

Section 1 - Procedures, Specs & Capabilities

Description

Overview of the stairway unit, chassis, A-frame, platform, stabilizers, engine, hydraulic, and electrical systems.

Operation

Details on operating controls, pre-operation checks, and step-by-step operating procedures for the stairway.

Specifications and Capabilities

Technical specifications including dimensions, capacities, engine, hydraulic, and electrical system details.

Special Tools and Equipment

Information on any specialized tools or equipment required for maintenance or repair of the stairway.

Section 2 - Servicing Passenger Stairway

Servicing

Preventive maintenance, lubrication, and component servicing for structural, engine, hydraulic, and electrical systems.

Troubleshooting

Guide to identifying and resolving common problems, their probable causes, and suggested remedies.

Adjustments

Procedures for adjusting key components like hydraulic pressure relief valves, flow controls, and engine settings.

Removal and Installation

Step-by-step instructions for removing and installing major assemblies, like the stair assembly.

Section 3 - Overhaul

Section 4 - Parts

Manufacturer Identification

Lists vendors and their codes for parts used in the passenger stairway.

Detailed Parts List

Comprehensive list of all parts, including figures, part numbers, descriptions, and quantities.

Understanding the Columns

Explanation of the data presented in the detailed parts list, such as figure/item numbers and part numbers.

How to Order Parts and Assemblies

Instructions and contact information for ordering replacement parts and assemblies for the stairway.

STINAR PS-813B/E Specifications

General IconGeneral
BrandSTINAR
ModelPS-813B/E
CategoryLifting Systems
LanguageEnglish