1. Open the battery cover and insert 2 x “D” batteries into the battery
compartment.
2. The Space Isolator should generally be placed near the entrance to a room
or area where you do not want the vacuum to enter.
3. Remove any obstacles from the area in front of the Space Isolator as much
as possible.
4. Use the toggle switch to set the distance of signal: Low/3m & High/6m.
5. Turn off the toggle switch when not in use to save the battery.
Installation Method of the Space Isolator
1. The Space Isolator should be placed at the same level as the
ground where the vacuum is running.
2. You should check whether the vacuum can pass the Space
Isolator before use.
3. The distance between the Space Isolator and the docking station
should be more than 3m or there will be interference.
4. The battery consumption is related to the selected transmitting
distance and working duration. Please select proper transmitting
distance and low transmitting power to save the battery. Don’t
forget to turn off the toggle switch while not in use.
5. You do not need to place the Space Isolator above stairs. Your
robot vacuum is equipped with three level sensors that recognise
staircases and other dips to ensure it will not fall.
Instructions Cont.
22
AFTER SALES SUPPORT
MODEL: EE-9248 PRODUCT CODE: 49631 06/2015
1800 898 750
AUS
service@wkfe.com.hk
To Next Page
Loading...
