For first time use, make sure the robot vacuum cleaner battery has been
fully charged for 12 hours for best performance.
Normal charge time will take within 4-5 hours before the battery is full again.
Getting Started
Setting the Remote Control
The remote control comes with two AAA batteries. Ensure these are correctly
loaded in the remote controller before getting started.
***The following steps are very important, or the remote control may fail.
You should check the code of the remote control and vacuum so that they can
function together.
1. Check that the remote control and cleaner have enough power. Turn off the
cleaner, press ENTER on the remote control for more than 4 seconds, and
then turn on the vacuum without releasing ENTER on the remote control. After
the cleaner beeps twice, release ENTER, then the code check set is finished.
2. If you fail to hear a beep during the code check, just repeat the above
process.
8
AFTER SALES SUPPORT
MODEL: EE-9248 PRODUCT CODE: 49631 06/2015
1800 898 750
AUS
service@wkfe.com.hk
To Next Page
Loading...
