Getting Started Cont.
Your robot vacuum cleaner is equipped with many practical functions that
allow it to clean wooden floors, short-pile carpet/rugs, tiles and vinyl flooring.
Ensure carpets/rugs are in good condition before use.
The device uses artificial intelligence (AI) to adjust to its environment and
reliably clean its working area. The device is equipped with three level
sensors that recognise staircases and other dips to ensure that it will not fall.
The robot vacuum cleaner works in 4 cleaning programmes: random, spiral,
along the wall and spiral again. This enables it to automatically tackle several
cleaning scenarios. The battery will last between 90 to 120 minutes and will
cover 250 to 280 square metres assuming it has been fully charged. During
this time the vacuum cleaner will work through these programmes in an
arbitrary sequence depending on the enviroment.
Turn on the power switch at the right side of the robot (See Fig. 1).
The LCD display will begin to flash.
Charging Your Vacuum
Before you first use your vacuum cleaner charge the battery overnight for 12
hours. It is also recommended that the battery is flat before you recharge for
the first 2 or 3 times. Alternatively, if the battery is very low the robot vacuum
will automatically return to the docking station to charge. Do not use again
until the full charge has completed.
Using Your Vacuum Cleaner
Auto Cleaning
The vacuum cleaner will start working through the 4 programmes for as long
as the battery will last. When the battery becomes low, it will automatically
return to the docking station to re-charge. It will stay there until you wish to
use it again.
Fig. 1
9
AFTER SALES SUPPORT
MODEL: EE-9248 PRODUCT CODE: 49631 06/2015
1800 898 750
AUS
service@wkfe.com.hk
Random Spiral Along the wall Spiral again
To Next Page
