To do this:
1. Press the “AUTO” button on the vacuum cleaner or remote control.
2. The vacuum will start cleaning. When the battery is low it will return to the
docking station to recharge and the Auto cleaning function is complete.
Full Go Cleaning
The vacuum cleaner will start working through the 4 programmes after the battery
has been fully charged. It will work continuously through the cleaning
programmes and re-charging cycle. This function is suitable for a large house
where one full charging cannot clean all the rooms. This way the vacuum will
continue to function until you stop it. It will return to the docking station to
re-charge every time the battery gets low.
To do this:
1. Press the “schedule” button on the remote control, then press “Full Go”.
After finishing Full Go setting, press “ENTER” to save it.
2. “F” in the “ ” icon on the LCD screen will flicker, and the vacuum will start
cleaning automatically when the battery is charged (4-5 hours charging).
Spot Cleaning
This function will clean a specific area about the size of 1 square metre.
Speeds
Fast speed moves more quickly than slow speed. The vacuum cleaner will clean
the area faster, but will not be as detailed as when working under the slow speed.
Slow speed is suggested if an area is dirtier than usual and requires extra
attention.
Cleaning System
The brushes on the side of the device sweep dust and dirt towards the suction
opening. Subsequently, the dirt particles are sucked into the dustbin. The HEPA
filter ensures that dirt particles remain on the floor of the dustbin so that only
clean air is expelled from the device.
The dustbin unit consists of the dustbin, air outlet, dust filter bracket and HEPA
dust filter. The unit can be removed without any tools.
Please refer to the Cleaning and Care sections in this manual.
Getting Started Cont.
10
AFTER SALES SUPPORT
MODEL: EE-9248 PRODUCT CODE: 49631 06/2015
1800 898 750
AUS
service@wkfe.com.hk
To Next Page
Loading...
