Stirling EE-9248 - Changing the HEPA Dust Filter; Cleaning the Mop Pad

6. Clean the HEPA dust filter with a hairdryer
or the dust brush (Refer Fig . 8 and Fig. 9).
7. After cleaning, assemble the unit as it was
before.
CAUTION:
Ensure the dustbin and the HEPA dust
filter are completely dry before reassembly.
Changing the HEPA Dust Filter
1. To change the dust filter, remove the dustbin
(step 1) and release the dust filter bracket
(step 5) as explained in the previous section.
2. Remove the filter by inserting your thumb in the
space between the filter and the bracket and
pulling the HEPA dust filter up out of the bracket.
3. Then replace by sliding and pushing a new
HEPA dust filter into place (Refer Fig. 10).
Cleaning the Mop Pad
1. Pull the mop pad off the velcro mop base. Wash them in your washing
machine. Dry them. Stick the mop pad back onto the velcro mop base
(Fig. 11).
Other Useful Information Cont.
Fig. 9
Fig. 8
Fig. 10
Fig. 11
24
AFTER SALES SUPPORT
MODEL: EE-9248 PRODUCT CODE: 49631 06/2015
1800 898 750
AUS
service@wkfe.com.hk
Do not use the velcro mop base and mop pad on carpet or uneven
ground.