31
To attach a tether to the stylus:
1. Hold the stylus with the STONEX logo facing upwards and insert the end of the
tether down through one of the two holes in the top of the stylus and then back up
through the other hole.
2. Insert the other end of the tether through the loop and pull until the knot in the
tether is tight.
3. Attach the tethered stylus to the handheld as described below.
To attach a tethered stylus to the handheld, feed the end of the tether through the top of
the stylus retainer on the rear of the handheld and then feed the end of the stylus through
the loop until the knot in the tether is tight.
3.4. Entering information
Depending on the program you are using, you can enter information in several ways, as
described below (Table 3.4.1 – Entering information):
Use Microsoft connection management software to exchange
information between the handheld and a PC.
Use the Keyboard input panel to enter typed text by tapping keys on the
on- screen keyboard.
Use the stylus like a pen to draw (or write) directly on the screen.
Create a stand-alone recording or embed a recording into a note.
Using the on-screen keyboard
The keyboard button automatically appears in the tile bar of any application.
To display the keyboard, tap the keyboard button or tap a text box in the application.
To enter characters use your finger or the stylus to tap the keys on the keyboard. When you
finish entering text in a field tap to accept the text you have entered and then move to
the next field.
To enter special characters tap to display keyboards containing numbers and symbols.
To switch back to the main keyboard tap again.
To hide the keyboard tap the keyboard icon again.
To Next Page
Loading...
