Stonex S900A GNSS Receiver – User Manual 11
Base Mode
Base mode also contains different datalink, most of the parameters are same.
The only difference is the base mode has some more options can be edited.
For example you can set the base data type, start base and base position and
so on.
If you select UHF mode, most of the settings are same as rover. But you can
set the radio power.
If you select Network, then besides set the data type, site ID, base position and
record raw data, the most important is you can input APN account, APN user
and password, connect mode, caster address and port.
To Next Page
Loading...
