Need help?Do you have a question about the STONEX S850+ and is the answer not in the manual?
Details S850+ recognition of RTK correction formats and datalink options in Rover mode.
Configures UHF radio settings for RTK corrections, including frequency, channel, and protocol.
Explains internet connection via SIM card or Wi-Fi for RTK corrections.
Configures UHF radio settings for S850+ in Base mode, including frequency and power.
Details network connection settings for S850+ in Base mode, including SIM/Wi-Fi and NTRIP caster.
Configures S850+ as standalone base using its internal caster via Wi-Fi.
Guides on updating receiver firmware, including precautions and factory reset.
Details S850+ registration process to ensure correct operation and avoid expiry issues.
Details activating and configuring the IMU sensor using Stonex Cube-a software.
Guides on enabling Pole Tilt Correction and setting sensor options within Stonex Cube-a.
Describes IMU sensor calibration process, including prerequisites and step-by-step instructions.
Explains IMU sensor initialization after activation, including magnetic and GNSS adjustments.
To Next Page
General
