Stonex S850
+
GNSS Receiver – User Manual 10
3.3 Static Survey
S850
+
it’s able to record raw data while working as a base or as a rover. In this page is possible to set the option
for raw data recording. Before changing any setting be sure that the device is not recording.
The point name can contain at maximum 4 alphanumeric characters, the antenna height can be measured with
five different methods as explained by the picture. Select the correct method so that the correct phase center
offset is applied.
Interval: define the frequency of the recording, from once every minute (60 S) to twenty time in a second (20
Hz).
Duration: define the length of a recording file. When a recording has reached the full duration, a new one will
start.
Enabling auto record after power on set the receiver to start recording raw data when is turn on, as soon as
the PDOP value is lower than the threshold set the recording will start.
Save: save the configuration without starting a recording
Start: will save the configuration and start the recording
To Next Page
Loading...
