STONEX S850+ - 3.5.2.3 External (Serial); 3.5.2.4 Bluetooth

Stonex S850
+
GNSS Receiver – User Manual 21
3.5.2.3 External (Serial)
By selecting External, the only setting necessary is the external port baud rate, it must match the receiver baud
rate. The serial port used for this datalink is the 5-pin port.
The baud rate available are:
• 9600
• 19200
• 38400
• 57600
• 115200
3.5.2.4 Bluetooth
Using Bluetooth datalink allows the transmission of the corrections via Bluetooth to another device (ex. SR02
external radio). It’s possible to scan for nearby Bluetooth devices, selecting a voice from the scan results will
automatically complete the Serial number and Mac address field
3.5.2.5 Dual
S850
+
can work at the same time with both External and Network datalink. Please refer to the respective
section for the configuration settings.