STOVES 600GR - Micro-Computer Operation

If in doubt, isolate the appliance from
the gas and electrical supplies &
contact Customer Care.
The 600GR oven grill unit uses a built
in micro-computer to control the oven
temperature. The computer also
indicates when the oven and grill are
ready for use, and oversees the gas
supply, fan operation and ignition
sequence ensuring that these are
operating safely.
Should the micro-computer find any
fault in the systems under its control, it
will either;
- stop the ignition and gas valve
operation or;
- if the cooker is already in use it will
shut down the operation until the
fault is rectified.
The cooling fan will however continue
to run, and the oven lights remain on.
Note:
Electrical interference either from the
mains or other electrical equipment
may cause the computer to indicate a
fault when non exists, chiefly when first
turning on.
It may be necessary to reset the micro-
computer (by turning the electricity
supply off at the mains plug) when first
bringing the appliance into operation.
In the event of a power cut
1. Switch off the appliance at the
socket.
2. When the power returns, see the
‘Programmer / Clock section to
‘Set the time of day’.
In the event of the gas supply being
disconnected it may be necessary to
make several lighting attempts before
gas reaches the appliance.
19
Lamp state Cause Action
Steady green Oven / grill has reached None - normal operation.
required temperature.
Flashing green Soft lockout Reset - turn control knob off / on.
Green ready light Hard lockout Reset - turn off / on at mains.
/ red indicator dial (possible interference) If recurring, a service visit may
flashing alternately be required.
Red indicator dial & green Fault on micro-computer Service visit required.
ready light flashing together
MICRO-COMPUTER OPERATION