Glass parts
FACIA PANEL & DOOR PANELS
Use a mild cream cleaner - eg; “Cif”.
Rinse thoroughly and dry with a soft
cloth. Do not
use abrasive cleaners or
polishes.
Important: the inner door glass
panel can be removed for cleaning but
it must be replaced the right way up as
shown (so the reflective side faces
inwards), and pushed fully in to the
stop position. To remove the glass
panel, open the door wide, hold the
top and bottom edges and slide out.
Painted, plastic and metal finish
parts
HANDLES & CONTROL KNOBS, OVEN DOOR
FRAME
Only use a clean cloth wrung out in
hot soapy water.
Stainless Steel surfaces
(stainless
steel finish models only)
FACIA PANEL, HANDLES, DOOR PANELS
Only use a clean cloth wrung out in hot
soapy water, and dry with a soft cloth.
Stubborn marks can be removed using
“Luneta”. We recommend that you
clean the whole of the stainless steel
area to maintain a uniform finish.
Supplies can be purchased from
H.R.P.C. - contact direct sales
order line on 01772 819 672.
Do not use undiluted bleach or any
products containing chlorides as they
can permanently damage the steel.
Extra care should be taken when cook-
ing food in salted water. Some foods
are corrosive - eg; vinegar, fruit juices
and especially salt
- they can mark or
damage stainless steel if they are left
on the surface. Turn off and wipe any
spillage immediately, taking care to
avoid skin contact with any hot surface
or spillage.
Sharp objects can mark the surface of
stainless steel, but marks will become
less noticeable with time.
To maintain the finish of the stainless
steel, or to remove any greasy marks,
wipe the stainless steel surface spar-
ingly with a minimum
amount of
“Johnson’s Baby Oil” and kitchen paper.
Do not use cooking oils, as these may
contain salt, which can damage the
stainless steel surface.
30
To Next Page
Loading...
