STRANDS S 28 M Flex - Safety Instructions; General Safety Instructions; During Installation

14
Safety Instructions
When used correctly, this is one of the best machines in terms of design and safety. However,
any machine that is used improperly can always pose a safety risk. It is absolutely necessary that
those persons using the machine have learned how to use it correctly. They should read and
understand this material as well all the signs on the machine. Neglecting to follow the safety
instructions can pose the risk of an accident.
Warning!
Improper use of this machine can cause serious personal injury.
The machine must be installed and maintained correctly.
General Safety instructions
All machines with rotating parts can cause accidents. Therefore, it is important that as an
operator, you are aware of the risk of an accident and follow the guidelines below:
• Wear clothing and personal safety equipment that cannot get caught in the rotating
drilling and tapping tools.
• Use eye protection if there is a risk of shavings or coolant splattering, or if there are local
regulations in this regard.
• Keep the area around the machine clean so that you do not trip and fall against the
rotating tool.
• Make sure that the work piece is properly fastened to the table. Never use your hands to
hold the work piece.
• Always make sure that the machine's electric switch is in the 0 position when changing
the drilling and tapping tools or cleaning the machine. Never brush shavings away while
the machine is working.
• Use proper drilling and tapping tools. Make sure that the proper speed and the proper
feed rate is set for the drilling and tapping tools. Be sure that the drilling and tapping
tools is intended for the work you are doing.
• Make sure that heads and tables are properly locked in place before starting.
During Installation
• Avoid installing the machine in damp, dirty or poorly lit environments.
• Make sure that the machine has all the necessary protection.
• Electrical installations should be performed by authorized electricians.
• Be sure that the machine is set up securely or anchored in place.