16
CE-Label and Declaration of Compliance
If this machine has a CE-label, then it upon delivery fulfils the appropriate "Critical Health and
Safety Requirements" specified in the EU:s Machine Safety Directive. If changes are made
which affect the machine's safety, the person making these changes is responsible for them.
As proof that the requirements have been met, an EU Declaration of Compliance is delivered
with each machine, prepared by Machinery Scandinavia AB. This EU declaration also covers
accessories manufactured by Machinery Scandinavia AB. The documentation is valuable and
should be properly preserved and should always accompany the machine when sold.
If the machine is used for other purposes or with accessories other than what is specified in these
instructions, its safety must be ensured in each individual case. Responsibility lies with the
person who operates it, and in certain cases a new CE-label or new EU Declaration of
Compliance may be required.
Installation
Set-up
• Check that the machine has not been damaged during transport. If this is the case, contact
our retail dealer immediately.
• Place the machine on a stable foundation. A soft rubber pad or similar item can be placed
between the machine's foot plate and the foundation. Anchor the machine with bolts if
required.
• Wash away the rust-protection that the machine is treated with during delivery. Do not
use too much solvent, since the solvent can also remove the lubrication.
Electrical Connection
• Electrical installations should always be performed by authorized electricians.
• Make sure that the correct voltage is supplied to the machine.
• Set up the electrical connections according to the attached circuitry diagram. Connect the
electricity with the attached cable and CEE connector.
Lubrication
All ball bearings and gear wheels are lubricated at the factory. Check the gear box's lubrication
after several years of use.
Lubricate the feed gear box (for machines equipped with one) and other movable parts by using
the lubricating cups.
The feed gear box's worm gear sits in an oil bath. Add oil via the filling hole up to the middle of
the level indicator (approx. 0.3 liters). Proper oil should have a viscosity of 11 °E at 50 °C. See
separate oil recommendations.
NOTE! Machines with automatic feed are not supplied with oil in the feed gearbox.
To Next Page
Loading...