Need help?Do you have a question about the Stratasys Dimension BST 1200 and is the answer not in the manual?
Explains formatting conventions like WARNING, CAUTION, and NOTE for important information.
Details references and resources available for using the Dimension system.
Provides step-by-step instructions for installing and configuring the Dimension system.
Offers guidance on operating the Dimension system and its software.
Lists all replaceable parts and consumables used with the Dimension modeling system.
Details the required physical space, environmental conditions, and power requirements for the printer.
Describes the recommended procedures for safely unpacking and preparing the Dimension printer for first use.
Instructions for attaching the covers that protect the forklift channels after installation.
Discusses the necessary steps to prepare and connect the printer to a power source.
Provides detailed instructions on how to safely power on the Dimension printer.
Step-by-step guide for properly inserting the modeling base into the printer's tray.
Details the installation process for the CatalystEX preprocessing software and system controller software.
Establishes communication between the PC and printer for sending print jobs over a network.
Instructions for establishing a direct connection between the Dimension printer and a PC.
Describes the main User Interface, including the display panel and context-sensitive keypad buttons.
Instructions for correctly inserting a modeling base into the printer for building parts.
Procedure for safely powering down the Dimension printer when not in use.
Discusses the process of completely removing and then restoring electrical power to the Dimension system.
Step-by-step guide for loading material cartridges into the Dimension printer.
Procedure for replacing or removing material cartridges from the printer.
Instructions for building preloaded test parts to familiarize users with the system's functionality.
Describes the procedures for preparing and sending CAD files to the Dimension printer for printing.
Details the process of building a part after the CMB file is sent to the printer via CatalystEX.
Explains how to control and set the chamber lights to be ON or OFF during operation.
Procedure to temporarily pause the printer's build operation, for tasks like material replacement.
Instructions on how to restart a paused build process.
Details how to continue operations after the printer enters its energy-saving Standby mode.
Procedure to stop and cancel a print job at any point during the building process.
Steps for safely removing a finished part from the printer and the modeling base.
Details how to remove support material, covering both Breakaway and Soluble types.
Lists the essential tools and replacement parts included in the Startup Kit for system maintenance.
Specifies routine tasks to be performed after completing each print job.
Details specific maintenance tasks recommended after approximately 500 hours of printer operation.
Step-by-step instructions for locating, cleaning, and reassembling the printer's fan filter.
Procedures for maintaining and replacing the brush and flicker components of the tip cleaning assembly.
Details specific maintenance tasks recommended after approximately 2000 hours of printer operation.
Instructions for cleaning and lubricating critical mechanical axes, including lead screws and guide rods.
Lists maintenance tasks that do not follow a fixed schedule but should be addressed as required.
Procedure to clear accumulated material buildup from the Z Platform and lead screw.
Instructions for using a vacuum to clean the build chamber of foreign particles and debris.
Guidance on how to properly clean the printer's chamber door glass.
Procedure for replacing a light bar in the build chamber when it burns out.
Procedure for cleaning the area behind the extrusion tips to remove material buildup.
Instructions for replacing torn or damaged tip shrouds to maintain print quality.
Covers the process of replacing extrusion tips, including necessary calibration steps.
A comprehensive list of common problems or error messages and their recommended solutions.
Explains how the system displays error codes and outlines initial steps for recovery.
Details procedures for diagnosing and rectifying issues related to material extrusion failures.
Methods for observing the printer to identify specific symptoms of material extrusion problems.
Step-by-step instructions to guide users through the process of recovering from material extrusion failures.
General| Brand | Stratasys |
|---|---|
| Model | Dimension BST 1200 |
| Category | 3D Printers |
| Language | English |
To Next Page
