Need help?Do you have a question about the Stratasys F120 and is the answer not in the manual?
Defines hazard classifications used throughout the guide.
Describes warning symbols for safe operation.
Identifies specific hazardous zones on the printer.
Outlines essential safety guidelines for users.
Steps to connect the printer via Ethernet.
Settings for network connectivity.
Describes the touchscreen and its controls.
UI functions related to managing print jobs.
Process for loading print jobs onto the printer.
Visual representation of print job progress.
Buttons for starting, pausing, or aborting prints.
Management of print jobs in the queue.
How to add new print files to the queue.
Managing printer materials and their status.
Accessing printer settings and functions.
Configuring printer preferences and defaults.
Procedures for calibrating printer functions.
Routine procedures for printer upkeep.
Configuration of network connections.
Step-by-step guide to turning the printer on.
Process for installing printing materials.
Procedures for replacing print heads.
Detailed steps for head replacement.
Essential steps for preparing and starting print jobs.
Preliminary actions required before starting a print.
Choosing and initiating a print job.
How to temporarily stop an active print job.
How to permanently stop an active print job.
Calibrating the print heads' tip positions.
Automated process for tip calibration.
Step-by-step manual tip calibration.
Methods for updating the printer's software.
Overview of recommended maintenance tasks.
Understanding and responding to alerts.
Issues that block build initiation.
Issues that cause a build to terminate.
A table of troubleshooting scenarios and solutions.
General| Printing Technology | Fused Deposition Modeling (FDM) |
|---|---|
| Layer Resolution | 0.254 mm (0.010 in) |
| Materials | PLA, ABS |
| Nozzle Diameter | 0.4 mm |
| Connectivity | USB, Ethernet |
| Operating System Compatibility | Windows |
| Power Requirements | 100-240V, 50/60 Hz |
To Next Page
