Stratasys F120 - Setting the Printers Date and Time; Updating the Controller Software Version; Adjusting the Tip Wipe Height

Basic Setup Setting the Printer’s Date and Time
Page 17
© Copyright 2020 Stratasys. All rights reserved.
Setting the Printer’s Date and Time
In order to ensure accurate build times, the printer’s clock must be set correctly. If you find that
your printer’s date and/or time are incorrect you can update them using GrabCAD Print. To do
so, navigate to
http://help.grabcad.com/article/196-printer-firmware-management and follow the
procedure for “Changing your printer’s clock time”.
Updating the Controller software Version
Update the Controller Software if necessary. See “Updating Controller Software” (page 146).
Adjusting the Tip Wipe Height
If necessary, adjust the tip wipe height. See “Tip Wipe Height Adjustment” (page 144).