Stratasys F120 - Build Pause Warnings

Warnings and Errors Build Pause Warnings
Page 198
© Copyright 2020 Stratasys. All rights reserved.
Invalid material
• Indicates that the installed material is not licensed for use with the printer.
•
Correct condition - to adjust your printer’s material license please contact Stratasys
C
ustomer Support or your regional Stratasys office (see “Getting Help” (page 192) for
contact information).
Cannot load model in to support head
• Indicates that you have inserted a model material coil box’s filament key into the wrong
f
ilament port in the printer.
• Correct condition - Remove the material key from its current location and insert it into the
u
pper filament port. See Figure 11 (page 27) for details.
Cannot load support in to model head
• Indicates that you have installed a support material coil box’s filament key into the wrong
f
ilament port in the printer.
• Correct condition - Remove the material key from its current location and insert it into the
l
ower filament port. See Figure 11 (page 27) for details.
Cannot change material type during build
• Indicates that the printer is currently in the process of building and you are attempting to
c
hange model or support material during the build.
• Correct condition - you cannot change material types while the printer is in the process of
b
uilding a part. Wait until the build is complete before changing materials.
Build Pause Warnings
User requested
• Indicates that a pause was initiated by the operator or inserted within the job’s file.
•
Correct condition - resume the build by pressing the P
lay button within the Build page (see
Table 3 (page 45) for button details).
Out of model material
• The printer has run out of model material.
•
Correct condition - disconnect the empty material coil box and replace as needed. See
“
Unloading Material” (page 105) and “Connecting Material Coil Box To Printer” (page 98)
for instructions.
Out of support material
• The printer has run out of support material.
•
Correct condition - disconnect the empty material coil box and replace as needed. See
“
Unloading Material” (page 105) and “Connecting Material Coil Box To Printer” (page 98)
for instructions.
Any pause not initiated by the operator will display a warning which must be
acknowledged on the User Interface before the printer can resume building.