Stratasys F120 - Page 206

Warnings and Errors Load/Unload Errors
Page 197
© Copyright 2020 Stratasys. All rights reserved.
• Correct condition - unload model and support material (see “Unloading Material”
(page 105)) and then reload these materials (see “Loading Material” (page 97)). Once
loaded, verify that material purges from the tips by performing a manual purge of each tip
us
ing the purge buttons within the Tip Maintenance page (see “Head Maintenance”
(page 58)).
Resource not available
• Indicates that the printer is in the process of completing another task and a load/unload
c
annot be started until the task is complete.
• Correct condition - wait a couple of minutes and then attempt to load/unload material.
Task alre
ady running
• Indicates that the printer is in the process of loading or unloading material. Only one
m
aterial coil box can be loaded or unloaded at a time.
• Correct condition - wait until the load/unload in process is complete before attempting to
l
oad material to or unload material.