Need help?Do you have a question about the Stratasys F123 Series and is the answer not in the manual?
Contacting Stratasys Customer Support for printer issues.
Basic safety tips for safe installation, operation, and maintenance.
Details on the contents of the printer's welcome kit.
Initial printer setup procedures including stabilizing and network connection.
Overview of the printer and its main access doors and panels.
Details about the gantry assembly and its movement.
Information on available materials, colors, and compatibility.
Overview of the printer's controller, GrabCAD Print, and Insight software.
General description of the touchscreen interface and its main areas.
How to load, start, pause, and abort print jobs.
Managing print jobs in the queue, adding, editing, and viewing details.
Monitoring and managing printer materials, heads, and their status.
Accessing and configuring printer settings, calibration, and maintenance.
Procedures for powering the printer ON and OFF.
Step-by-step instructions for preparing and loading material spools.
Procedures for removing material spools from the printer.
Guidance on how to replace printer heads.
Procedures for calibrating print tips to ensure accuracy.
Steps to recalibrate the printer's touchscreen display.
Automatic calibration for X and Y axes to ensure proper movement.
Automatic calibration for the Z axis to ensure proper build plate positioning.
Methods for updating the printer's controller software.
How to export printer configuration files for backup or support.
Overview of recommended weekly, monthly, and as-needed maintenance tasks.
Information on contacting support and troubleshooting resources.
Explains how warnings and errors are displayed and indicated.
Information regarding product compliance and certifications.
Details on EMC, FCC, and Canadian safety and compatibility regulations.
General| Build Volume (F170) | 254 x 254 x 254 mm (10 x 10 x 10 in) |
|---|---|
| Build Volume (F370) | 355 x 254 x 355 mm (14 x 10 x 14 in) |
| Software | GrabCAD Print |
| Technology | Fused Deposition Modeling (FDM) |
| Materials | ASA |
| Connectivity | Ethernet, Wi-Fi |
| Operating System Compatibility | Windows |
| Power Requirements | 100-240 V, 50/60 Hz |
To Next Page
