Need help?Do you have a question about the Stratasys Fortus 380mc and is the answer not in the manual?
General| Print Technology | Fused Deposition Modeling (FDM) |
|---|---|
| Layer Thickness | 0.127 mm |
| Materials | ABS-M30, ABS-ESD7, ABS-M30i, ASA, PC-ABS, PC |
| Operating Voltage | 200-240 VAC, 50/60 Hz, single phase |
| Connectivity | Ethernet |
| Software | GrabCAD Print |
| Support Material | SR-30 |
| Power Requirements | 200-240 VAC, 50/60 Hz |
| Material Delivery | Cartridge-based system |
To Next Page
