What to do if task already running on Stratasys F370 3D Printers?
If a task is already running on your Stratasys 3D printer, wait until the load/unload in process is complete before attempting to load material to or unload material from another material bay.
What to do if my Stratasys F370 3D Printers is out of support material?
If your Stratasys 3D printer is out of support material, remove the empty material spool(s) and replace them as needed.
When to replace model head in Stratasys F370?
If the model head on your Stratasys 3D printer has reached its odometer limit of 1500 build hours, it is recommended that you change the head prior to starting a new build.
What to do if Stratasys F370 3D Printers shows file not found?
If your Stratasys 3D printer displays 'File not found', ensure that the USB flash drive containing the selected job file is securely inserted into one of the USB ports.
What to do if cannot load model in to support head in Stratasys F370 3D Printers?
If your Stratasys 3D printer indicates that you cannot load model in to support head, remove the model spool from its current location within the material bay and insert it into a model material bay.
What to do if model filament broken in Stratasys F370?
If the model filament is broken in your Stratasys 3D printer, remove the material spool and clear all filament from the filament tubes.
What to do if support head not initialized in Stratasys 3D Printers?
If the support head is not initialized on your Stratasys 3D printer, wait at least 60 seconds after the error is first displayed.
What to do if Stratasys 3D Printers is busy?
If your Stratasys 3D printer is busy, wait a couple of minutes and then attempt to restart the build.
How to fix close the door error on Stratasys F370?
To resolve the 'Close the door' message on your Stratasys 3D printer, close the oven door.
What to do if support material does not match selected job in Stratasys F370?
If the support material does not match the selected job on your Stratasys 3D printer, unload the incorrect support material and load the correct support material for the selected job.
Basic safety tips for printer installation, operation, and maintenance.
Steps for stabilizing, identifying, and connecting the printer.
Covers loading files, viewing job info, build status, and queue operations.
Details on managing materials and heads, including status, details, and maintenance.
Accessing and configuring printer settings, calibration, maintenance, network, power, and light.
Procedures for powering the printer ON and OFF.
Steps for loading, unloading, and storing material spools.
Instructions for replacing standard and PLA model print heads.
Steps from preparing the printer to completing a build and managing defaults.
Procedures for automatic and manual tip calibration.
Explains warnings and errors encountered during operation.
General| Technology | Fused Deposition Modeling (FDM) |
|---|---|
| Build Volume | 355 x 254 x 355 mm (14 x 10 x 14 in) |
| Connectivity | Ethernet, USB |
| Software | GrabCAD Print |
| System Weight | 227 kg (500 lbs) |
| Layer Thickness | 0.127 - 0.330 mm (0.005 - 0.013 in) |
| Material Compatibility | ABS, ASA, PC-ABS |
To Next Page
