36
TIPS AND SLICE HEIGHT
The F123 Series utilizes a T14 tip for all model and support materials. Tips are a component of the associated
head assembly and cannot be changed individually. Instead, the entire head assembly is replaced as a single
unit.
Table 3-3 lists the types of model material available for use with the printer and their corresponding support
material.
Table 3-4 lists available slice heights.
Table 3-3: Available Material Types
Table 3-4: Slice Height
*Available in “Draft” mode only
Model Material Support Material
ASA QSR
ABS QSR
PLA PLA
PC-ABS QSR
Model Tip Slice Height (in) Slice Height (mm) Material
T14 0.005 0.127 ABS, ASA, PC-ABS
0.007 0.178 ABS, ASA, PC-ABS
0.010 0.254 ABS, ASA, PC-ABS, PLA*
0.013 0.330 ABS, ASA, PC-ABS
To Next Page
Loading...
