19
INSTALLING GRABCAD PRINT
Install the GrabCAD Print software on a facility workstation. Navigate to http://help.grabcad.com/article/197-
sign-up-download-and-install and follow the on-screen instructions.
CONNECTING TO THE F123 SERIES PRINTER
Add the F123 Series printer to the GrabCAD Print application. Navigate to http://help.grabcad.com/article/198-
connect-your-printers and follow the on-screen instructions.
SETTING THE PRINTER’S DATE AND TIME
In order to ensure accurate build times, the printer’s clock must be set correctly. If you find that your printer’s
date and/or time are incorrect you can update them using GrabCAD Print. To do so, navigate to
http://help.grabcad.com/article/196-printer-firmware-management and follow the procedure for “Changing your
printer’s clock time”.
UPDATING THE CONTROLLER SOFTWARE VERSION
Update the Controller Software if necessary. See “Updating Controller Software” on page 158.
ADJUSTING THE TIP WIPE HEIGHT
If necessary, adjust the tip wipe height. See “Tip Wipe Height Adjustment” on page 157.
To Next Page
Loading...
