How to fix support head not communicating in Stratasys F370 3D Printers?
If the support head is not communicating on your Stratasys 3D printer, open the top cover and unclip the head cable from the support head.
What to do if model head not initialized in Stratasys 3D Printers?
If the model head is not initialized on your Stratasys 3D printer, wait at least 60 seconds after the error is first displayed.
What to do if support head not initialized in Stratasys 3D Printers?
If the support head is not initialized on your Stratasys 3D printer, wait at least 60 seconds after the error is first displayed.
What to do if Stratasys 3D Printers is busy?
If your Stratasys 3D printer is busy, wait a couple of minutes and then attempt to restart the build.
How to remove the part from Stratasys F370 3D Printers?
To remove the part from your Stratasys 3D printer, open the oven door and remove the completed part.
How to select a job on Stratasys 3D Printers?
To select a job on your Stratasys 3D printer, select the job you’d like to build from the Job Queue.
How to fix cooler module not installed error on Stratasys F370?
If the cooler module is not installed on your Stratasys 3D printer, install the bead cooler.
What to do if Stratasys 3D Printers timed out?
If your Stratasys 3D printer has timed out, remove the material spool and ensure that it is properly prepared for installation and load.
What to do if purge failed on Stratasys 3D Printers?
If the purge failed on your Stratasys 3D printer, unload model and support material and then reload these materials.
Basic safety tips for printer installation, operation, and maintenance.
Steps for stabilizing, identifying, and connecting the printer.
Covers loading files, viewing job info, build status, and queue operations.
Details on managing materials and heads, including status, details, and maintenance.
Accessing and configuring printer settings, calibration, maintenance, network, power, and light.
Procedures for powering the printer ON and OFF.
Steps for loading, unloading, and storing material spools.
Instructions for replacing standard and PLA model print heads.
Steps from preparing the printer to completing a build and managing defaults.
Procedures for automatic and manual tip calibration.
Explains warnings and errors encountered during operation.
General| Technology | Fused Deposition Modeling (FDM) |
|---|---|
| Build Volume | 355 x 254 x 355 mm (14 x 10 x 14 in) |
| Connectivity | Ethernet, USB |
| Software | GrabCAD Print |
| System Weight | 227 kg (500 lbs) |
| Layer Thickness | 0.127 - 0.330 mm (0.005 - 0.013 in) |
| Material Compatibility | ABS, ASA, PC-ABS |
To Next Page
