Stratasys F120 - Build Abort Errors

Warnings and Errors Build Abort Errors
Page 201
© Copyright 2020 Stratasys. All rights reserved.
Build Abort Errors
Aborted by user
• Indicates that the abort was initiated by the operator.
•
Correct condition - remove the aborted build from the printer, see “
Removing a Part from
the Printer” (page 119) for instructions.
Failed to find Z zero
• Indicates that the Z stage failed to find its home position.
•
Correct condition - verify that there is nothing obstructing the calibration targets on the
p
laten, see “Cleaning the Platen” (page 154) for instructions.
Failed to process the part
• An error occurred when attempting to translate the CMB file into commands for the printer.
•
Correct condition - often the result of a corrupted or outdated CMB file. Ensure that your
p
rinter’s software version is up to date (see “Updating Controller Software” (page 146)) and
that you are using the correct version of GrabCAD Print software. Reprocess, reorient, and
re
send the job file to the printer using GrabCAD Print (see “GrabCAD Print Software”
(page 33)) and then restart the build (see “Basic Job Build Tasks” (page 110) for
instructions).
Failed to load toolpaths
• Printer unexpectedly lost job information during the build.
•
Correct condition - reprocess, reorient, and resend the job file to the printer using GrabCAD
P
rint (see “GrabCAD Print Software” (page 33)). If you encounter the same error when
rebuilding with the reprocessed file, attempt to build a different file to see if the error occurs
ag
ain. If so, contact Stratasys Customer Support or your regional Stratasys office (see
“Getting Help” (page 192) for contact information).
Failed to calibrate tip offsets
• Indicates that the printer failed to calibrate tip offsets.
•
Correct condition - perform an automatic tip calibration (“
Automatic Tip Calibration”
(page 130)). If calibration fails, perform a manual tip calibration (“Manual Tip Calibration”
(page 133)). If calibration fails again, contact Stratasys C
ustomer Support or your regional
Stratasys office (see “Getting Help” (page 192) for contact information).
Active spool removed
• Indicates that the active material coil box was disconnected. This is only displayed when
t
he printer is preparing for a build.
• Correct condition - install a material coil box and load model material. See “
Connecting
Material Coil Box To Printer” (page 98) and “Loading Material” (page 97) for instructions.
All abort related errors must be acknowledged on the User Interface before the printer
is put into an aborted state.