Stratasys F120 - Page 211

Warnings and Errors Build Abort Errors
Page 202
© Copyright 2020 Stratasys. All rights reserved.
Model head removed
• Indicates that the printer lost contact with the model head.
•
Correct condition - ensure that the head is seated correctly within the gantry. If so, remove
t
he head and then reinstall it. If this does not correct the error, remove the head and install
a new head.
Support head removed
• Indicates that the printer lost contact with the support head.
•
Correct condition - ensure that the head is seated correctly within the gantry. If so, remove
t
he head and then reinstall it. If this does not correct the error, remove the head and install
a new head.
File not found
• Indicates that the printer was unable to locate the job file that was selected for building.
T
his error pertains to job files loaded via USB flash drive only.
• Correct condition - ensure that the USB flash drive containing the selected job file is
s
ecurely inserted into one of the USB ports within the interface panel (see
Figure 3 (page 20) for port locations). Once the flash drive is securely inserted into one of
the printer’s USB ports select the file you’d like to build by loading it to the Job Queue (see
“USB Method” (page 47)).
Unknown error
• An unexpected error occurred in which the printer was unable to map the cause of the error
t
o a known abort reason.
• Correct condition - attempt to restart the build, see “
Basic Job Build Tasks” (page 110) for
instructions. If the error persists, contact Stratasys C
ustomer Support or your regional
Stratasys office (see “Getting Help” (page 192) for contact information).
The warnings and errors listed below are displayed within the notifications area of the
Head Details page. See
“Viewing Head Details” (page 57) for details.