Stratasys F120 - Warnings at Build Start

Warnings and Errors Warnings at Build Start
Page 193
© Copyright 2020 Stratasys. All rights reserved.
Warnings at Build Start
Model material does not match selected job
• The model material currently installed does not match the model material configuration of
t
he selected job.
• Correct condition - unload incorrect model material and load the correct model material for
t
he selected job. See “Unloading Material” (page 105) and “Loading Material” (page 97) for
instructions.
Support material does not match selected job
• The support material currently installed does not match the support material configuration
o
f the selected job.
• Correct condition - unload incorrect support material and load the correct support material
f
or the selected job. See “Unloading Material” (page 105) and “Loading Material” (page 97)
for instructions.
Insufficient model material for part build
• The amount of model material currently installed in the printer is not sufficient for the
s
elected build.
• Correct condition - connect a material coil box to the printer that contains a sufficient
a
mount of model material. See “Loading Material” (page 97) for instructions.
Insufficient support material for part build
• The amount of support material currently installed in the printer is not sufficient for the
s
elected build.
• Correct condition - connect a material coil box to the printer that contains a sufficient amout
o
f support material. See “Loading Material” (page 97) for instructions.
Order new model head
• The model head has reached 1350 build hours, and is near its odometer limit. Build hours
a
re available within the head’s Head Details page (see “Viewing Head Details” (page 57)).
• Correct condition - you are still able to build using this head, but part quality may be
a
ffected. Once the head’s odometer limit is reached, you will be prompted to change the
head (see “Head Replacement” (page 108)).
Order new support head
• The support head has reached 1350 build hours, and is near its odometer limit. Build hours
a
re available within the head’s Head Details page (see “Viewing Head Details” (page 57)).
• Correct condition - you are still able to build using this head, but part quality may be
a
ffected. Once the head’s odometer limit is reached, you will be prompted to change the
head (see “Head Replacement” (page 108)).
Replace model head
• The model head has reached 1500 build hours (odometer limit). Build hours are available
w
ithin the head’s Head Details page (see “Viewing Head Details” (page 57)).