Working with the Build Page Print Job Controls
Page 44
© Copyright 2020 Stratasys. All rights reserved.
Print Job Controls
A button is displayed within the Build page, just beneath the Build Status Display. This button is
used to start, pause, or abort a build, depending on the status of the printer. The Print button
option will become selectable after you’ve performed the steps necessary to load a file (see
“Loading a File” (page 38)) and the printer is in a state where it is ready to build a part. This
button will toggle to display the Pause and Abort button options when a build is in process.
Figure 13: Print Job Controls
Print Button
The Print button allows you to start a build (see “Selecting a Job to Build” (page 112) for more
information). The Print button can appear in the following states:
Table 2: Print Job Controls - Print Button States
Button State Description
• Printer is in a buildable state AND a selected job is available to
build.
• Selecting the Print button will begin the build.
•
Print button is disabled and not selectable.
•
Printer is not in a buildable state OR a job is not selected/
a
vailable to build (i.e. queue is empty).
• To troubleshoot this issue, touch the text displayed on the
s
creen within the Notifications Display. This will open a dialog
allowing you to view the reason(s) for the current build state,
including any issues impeding your ability to start a build (i.e. no
substrate, etc.). See “Warnings at Build Start” (page 193) and
“Errors Preventing a Build from Starting” (page 194) for more
information.
To Next Page
Loading...
