Stratasys F120 - Top Cover Assembly

Customer Replaceable Units Top Cover Assembly
Page 166
© Copyright 2020 Stratasys. All rights reserved.
Installing the Louver Panels
1. Engage the slotted mounting bracket of the louver panel with the rear cover standoff
fastener.
2. Align the louver panel mounting holes (2) with the holes in the cover buttress.
3
. Use a 3 mm hex wrench to reinstall the mounting screws (2) that secure the louver panel to
t
he cover buttress. Torque to 21 in-lbs. See Figure 20 (page 165).
4. Use a 3 mm hex wrench to reinstall the louver panel mounting screws (3) that secure the
l
ouver panel to the cover support bracket. See Figure 20 (page 165). Torque to 30 in-lbs.
5. Install the right side panel. See “
Installing the Side Panels” (page 164).
6. Install the rear panel. See Installing the Rear Panel on page 5-7.
Top Cover Assembly
Required Tools
• 3mm hex wrench
• 5 mm hex wrench
Removing the Top Cover
1. Power off the printer. See “Powering OFF the Printer” (page 159).
2. Remove the rear panel. See “
Removing the Rear Panel” (page 161)
3. Remove the right and left side panels. See “
Removing the Side Panels” (page 162).
4. Remove the right and left side louver panels. See “
Removing the Louver Panels”
(page 165).
5. Using a 5 mm hex wrench, remove the screws (2) that secure the back cover to the top of
t
he printer frame.
6. Open the oven door to release the top cover latch.
7
. Open the front top cover.
8
. Using a 3 mm hex wrench, remove the screws (4) that secure the cover assembly
b
uttresses to the left and right side support brackets. See Figure 21 (page 167).
9. While holding the front cover open, gently disengage the cover buttresses from the
r
etaining pins on the left and right side support brackets. See Figure 21 (page 167).