Stratasys F120 - Tips and Slice Height

Modeling Materials Tips and Slice Height
Page 32
© Copyright 2020 Stratasys. All rights reserved.
Tips and Slice Height
The F120 utilizes a T14 tip for all model and support materials. Tips are a component of the
associated head assembly and cannot be changed individually. Instead, the entire head
assembly is replaced as a single unit.
Table 3 (page 32) lists the types of model material available for use with the printer and their
corresponding support material.
Table 4 (page 32) lists available slice heights.
Table 3: Available Material Types
Model Material Support Material
ASA SR30
ABS SR30
Table 4: Slice Height
Model Tip Slice Height (in) Slice Height (mm) Material
T14
0.007 0.178 ABS, ASA
0.010 0.254 ABS, ASA
0.013 0.330 ABS, ASA