Stratasys F120 - Errors Preventing a Build from Starting

Warnings and Errors Errors Preventing a Build from Starting
Page 194
© Copyright 2020 Stratasys. All rights reserved.
• Correct condition - you are able to continue building using this head but it is recommended
that you change the head prior to starting a new build (see “Head Replacement”
(page 108)).
Replace support head
• The support head has reached 1500 build hours (odometer limit). Build hours are available
w
ithin the head’s Head Details page (see “Viewing Head Details” (page 57)).
• Correct condition - you are able to continue building using this head but it is recommended
t
hat you change the head prior to starting a new build (see “Head Replacement”
(page 108)).
Errors Preventing a Build from Starting
Printer busy
• Indicates that the printer is in the process of completing another task and a build cannot be
s
tarted until the task is complete.
• Correct condition - wait a couple of minutes and then attempt to restart the build.
Close the
door
• Indicates that the oven door is open.
•
Correct condition - close the oven door.
Close the
cover
• Indicates that the top cover is open.
•
Correct condition - close the top cover.
Remove th
e part
• Indicates that the completed part from the previously built job is still in the printer’s oven
c
hamber.
• Correct condition - open the oven door and remove the completed part. See “
Removing a
Part from the Printer” (page 119) for instructions.
Select a job
• Indicates that a job has not been selected for building.
•
Correct condition - select the job you’d like to build from the Job Queue. See “
Selecting a
Job to Build” (page 112) for instructions.
Insert a model head
• Indicates that a model head has not been installed into the printer.
•
Correct condition - install model head. See “
Head Replacement” (page 108) for
instructions.