Modeling Materials Materials Used
Page 29
© Copyright 2020 Stratasys. All rights reserved.
replacement head as the head is nearing its odometer limit. You can continue using a head
which has exceeded its odometer limit, but it is highly recommended that you change the head
as part quality will be unpredictable. The corresponding Head Status Icon will be displayed in
its warning state on the User Interface (seeTable 6 (page 55) for icon states). The entire model
or support head assembly is replaced as a single unit (see “Head Replacement” (page 108) for
instructions). The Head Release Lever locks and unlocks the associated head into or out of its
se
ated position.
Figure 13: Head Assemblies
Modeling Materials
Materials Used
The F120 printer can use a variety of model materials, in a range of colors. SR30 Soluble
Release support material is used in conjunction with all model materials. See Table 3 (page 32)
for model and support compatibility information.
Table 1 (page 30) lists the material types available for use with each printer model.
Support Head
Assembly
Model Head
Assembly
Head Release Lever (one
per head assembly)
To Next Page
Loading...
