Stratasys F120 - Load;Unload Errors

Warnings and Errors Load/Unload Errors
Page 196
© Copyright 2020 Stratasys. All rights reserved.
Load model material
• Indicates that model material has not been loaded into the printer.
•
Correct condition - load model material. See “
Loading Material” (page 97) for instructions.
Load support material
• Indicates that support material has not been loaded into the printer.
•
Correct condition - load support material. See “
Loading Material” (page 97) for instructions.
Replace invalid model spool
• Indicates that the material coil box is invalid. Invalid materials are materials not licensed or
n
ot compatible with the associated head type.
• Correct condition - disconnect the invalid material coil box and replace it with a valid
m
aterial coil box. See “Unloading Material” (page 105) and “Connecting Material Coil Box
To Printer” (page 98) for instructions.
Replace invalid support spool
• Indicates that the material coil box is invalid. Invalid materials are materials not licensed or
n
ot compatible with the associated head type.
• Correct condition - disconnect the invalid material coil box and replace it with a valid
m
aterial coil box. See “Unloading Material” (page 105) and “Connecting Material Coil Box
To Printer” (page 98) for instructions.
Replace empty model spool
• Indicates that the material coil box has run out of material.
•
Correct condition - disconnect the empty material coil box and replace with a new material
c
oil box. See “Unloading Material” (page 105) and “Connecting Material Coil Box To
Printer” (page 98) for instructions.
Replace empty support spool
• Indicates that the material coil box has run out of material.
•
Correct condition - remove the empty material coil box and replace with a new material coil
b
ox. See “Unloading Material” (page 105) and “Connecting Material Coil Box To Printer”
(page 98) for instructions.
Load/Unload Errors
Timed out
• Indicates that filament was not detected at the head within 5 minutes of a load’s initiation.
•
Correct condition - disconnect the material coil box and ensure that it is properly prepared
f
or installation and load. See “Material Coil Box Preparation” (page 97) and “Connecting
Material Coil Box To Printer” (page 98) for details. reconnect the material coil box (see
“Loading Material” (page 97)).
Purge failed
• Indicates that filament is currently in the head, but the load failed.