Stratasys F120 - Page 209

Warnings and Errors Build Pause Warnings
Page 200
© Copyright 2020 Stratasys. All rights reserved.
Model head removed
• Indicates that the printer lost contact with the model head.
•
Correct condition - ensure that the head is seated correctly within the gantry. If so, remove
t
he head and then reinstall it (see “Head Replacement” (page 108)). If this does not correct
the error, remove the head and install a new head.
Support head removed
• Indicates that the printer lost contact with the support head.
•
Correct condition - ensure that the head is seated correctly within the gantry. If so, remove
t
he head and then reinstall it (see “Head Replacement” (page 108)). If this does not correct
the error, remove the head and install a new head.