Stratasys F120 - Page 208

Warnings and Errors Build Pause Warnings
Page 199
© Copyright 2020 Stratasys. All rights reserved.
Active model spool removed
• Indicates that the printer lost contact with the model material coil box’s memory chip.
•
Correct condition - ensure that the filament key is seated correctly within its filament port. If
s
o, disconnect and then reconnect the material coil box (see “Unloading Material”
(page 105) and “Connecting Material Coil Box To Printer” (page 98)). If this does not
correct the error, disconnect the current material coil box and connect a new one.
Active support spool removed
• Indicates that the printer lost contact with the support material coil box’s memory chip.
•
Correct condition - ensure that the filament key is seated correctly within its filament port. If
s
o, disconnect and then reconnect the material coil box (see “Unloading Material”
(page 105) and “Connecting Material Coil Box To Printer” (page 98)). If this does not
correct the error, disconnect the current material coil box and connect a new one.