Stratasys F120 - XY Gantry Calibration

Tip Calibration Manual Tip Calibration
Page 134
© Copyright 2020 Stratasys. All rights reserved.
• The Heating/Cooling status displays the current temperature as well as the target
set point.
• The Preparing status will display as the system purges material and detects the
t
ray level.
• The Printing status displays the number of build layers complete or the amount of
t
ime remaining. Tap the screen to toggle between layers or time.
f. Once the calibration part is complete "DONE" will be displayed on the User Interface.
R
emove the substrate from the platen. You will analyze the part on the substrate to
determine correction values.
g. P
ress the N
ext button in the upper-right corner of the page; the Manual Tip Calibration
page will be displayed.
Figure 9: Manual Tip Calibration Page
The amount of time that the printer remains in the Heating/Cooling stage may vary
depending on the current oven chamber temperature.
After removing the substrate containing the calibration part and closing the oven
door, a message is displayed stating “Is the tray ready for another job?”. Press
No to return to the Manual Tip Calibration screen.
Sliding scale
icons (4)
Up and down
adjustment
buttons for
adjusting the
Z-offset