Need help?Do you have a question about the Stratasys uPrint and is the answer not in the manual?
Lists crucial safety precautions for printer setup, operation, and handling to prevent damage and injury.
Details the installation process for CatalystEX and system firmware on the workstation.
Explains methods for establishing a connection between the printer and the workstation.
Steps to connect the printer using a dynamic IP address via a network hub.
Steps to connect the printer using a static IP address directly or via a network.
Instructions for configuring static IP settings directly on the printer's control panel.
Steps to establish communication after network setup is complete.
Procedure for updating the printer's operating system firmware from a workstation.
Steps to initiate a build from the CatalystEX workstation interface.
Steps to initiate a build directly from the printer's display panel.
Procedures for pausing a build and resuming it later.
Steps to safely stop and cancel a build in progress.
Instructions for safely removing a finished part from the printer.
Steps for unloading and loading material spools in a single material bay.
Steps for unloading and loading material spools in dual material bays.
Detailed instructions for removing and installing material spools into carriers.
Guide to checking for and installing printer firmware updates.
Detailed steps for loading new firmware onto the printer.
Covers daily tasks like emptying the purge bucket and inspecting components.
Procedure for replacing the tip wipe assembly, typically every 500 hours.
Procedure for replacing and calibrating extrusion tips after 2000 hours of use.
Step-by-step guide for removing old and installing new extrusion tips.
Process for calibrating the printer's extrusion tips after replacement.
Solutions for common issues like no power, material extrusion failure, and display errors.
Guidance on understanding and resolving fault determination codes displayed by the printer.
Troubleshooting steps for errors encountered during the part building process.
Solutions for specific error messages related to material, loading, and unloading.
General| Technology | Fused Deposition Modeling (FDM) |
|---|---|
| Build Volume | 203 x 152 x 152 mm (8 x 6 x 6 in) |
| Layer Resolution | 0.254 mm (0.010 in) |
| Software | CatalystEX |
| Machine Dimensions | 635 x 660 x 787 mm (25 x 26 x 31 in) |
| Machine Weight | 76 kg (168 lbs) |
| Number of Model Materials | 1 |
| Number of Support Materials | 1 |
| Materials | ABSplus |
| Connectivity | Ethernet |
| Workstation Compatibility | Windows |
| Power Requirements | 100–120 VAC, 50/60 Hz, 15A or 220–240 VAC, 50/60 Hz, 7A |
| Resolution | 0.254 mm (0.010 in) |
To Next Page